Therefore, move SoundSport headphone close to the device. If wireless headphone is more than the required range from the device, it will not establish a connection with the device. The recommended Bluetooth range for SoundSport is within 33 feet or 10 meters. Solution 3: Check distance between SoundSport headphone and device If wireless headphone and Bluetooth device has been previously paired to, it will automatically connect whenever Bluetooth setting is enabled. Therefore, make sure to enable Bluetooth on device. If Bluetooth settings on device is disabled, it will not establish a Bluetooth connection to Bose product. Solution 2: Enable Bluetooth settings menu Although it is recommended to charge the headphone when needed, just make sure to disconnect the headphone from its charger if you want to connect to a Bluetooth device. When the headphone is charging, it will automatically disable its Bluetooth settings. If you are unable to connect to Bluetooth device with SoundSport headphones, try the following: Solution 1: Disconnect headphone from charger
The Dyson Zone is due to go on sale in the Autumn for an as-yet unannounced premium price expected to be in the £500 to £1,000 range.The process in connecting Bose products to a Bluetooth device is a simple and easy process there are however instances where certain issues can occur such not being able to connect to a Bluetooth device using Bose SoundSport wireless headphones. They last up to 40 hours when used just as headphones, fast charge via USB-C to 60% in 20 minutes and can be used when charging if required. The battery lasts up to 4.5 hours at the Zone’s lowest purification rate or 90 minutes at maximum, intended to only be used for short periods. The headphones can be used without purification by detaching the visor too. Meanwhile active noise cancellation technology, similar to that found in Bose, Sony and other headphones popular with commuters, uses microphones to monitor the sound of the outside world and the spinning compressors either side of the wearer’s head to remove it via anti-sound waves played into the ear cups. Dyson also has an additional mask attachment that sits between the visor and face, including a FFP2 filter, developed in response to the masking requirements of the Covid-19 pandemic. The visor has size-adjustable arms and is attached to the headphones via magnets that can be unclipped or unhinged so that it drops down to the wearer’s chin pausing the fans to allow them to speak to others. The large headphones and visor across the face will stand out on the street and wouldn’t look out of place in a sci-fi movie. An air quality sensor in the left ear cup monitors real-time pollution levels sending the data to an app on your phone and telling you when to replace the filters, which should last for about 12 months of use in Europe or less in more polluted environments. The headphones have sensors that detect how fast the wearer is moving, automatically adjusting the airflow between three intensity levels to ensure they deliver up to 5 litres of clean air a second, the equivalent breathing rate of a jog. The filtered air is then pushed along the inside of a visor, which sits just in front of the mouth and nose without making contact with the skin, creating a pocket of clean air for the wearer to breathe. The air is drawn through the filters cleaning it of 99% of particles as small as 0.1 microns, including pollen, bacteria and dust, as well as gas pollutants such as sulphur or nitrogen dioxide.
The eyebrow-raising design has a motor, compressor fan and air purifying dual-layer filter in each ear cup.
The product took six years and 500 prototypes to develop into its final form, which while heavy for a set of headphones attempts to balance the weight evenly across the head.